Cornelius Flavor Fusion 620053922 Informacje Techniczne Pobierz pdf (Strona 7)

FlavorFusion™ Training Manual

PROGRAMMING

The programming mode is exactly the same for both brand and bonus keypads.

To enter the programming mode, press and hold the two program buttons (see FIGURE 3) at the top of

the keypad for approximately 4 seconds. All keypad LEDs will flash off for approximately 1 second to

indicate the start of the programming mode.

To exit programming mode, press and hold the two program buttons for approximately 4 seconds. All

keypad LEDs will flash off for approximately 1 second, resuming normal operation mode.

Programming Mode Flashing Sequences

Once in programming mode, each dispense button LED flashes in a sequence cycle according to one (1)

of six (6) dispense types. For Brand Keypads, only dispense types 1 and 2 are used. For Bonus Flavor

Keypads, dispense types 3 through 6 are used. The six (6) dispense types are described below, and

shown in a timing diagram in FIGURE 1:

• Dispense Type 1, Carbonated water dispense: Solid LED

• Dispense Type 2, Non-carbonated dispense: Flashing LED 1.5 seconds ON, 1.5 seconds OFF

• Dispense Type 3, 1-second flavor shot: LED flashes once for ¼ second, followed by 3 seconds

OFF

• Dispense Type 4, 2-second flavor shot: LED flashes twice for ¼ second ON, ½ second OFF,

followed by 3 seconds OFF

• Dispense Type 5, 3-second flavor shot: LED flashes three (3) times for ¼ second ON, ½ second

OFF, followed by 3 seconds OFF

• Dispense Type 6, 4-second flavor shot: LED flashes four (4) times for ¼ second ON, ½ second

OFF, followed by 3 seconds OFF

FIGURE 1

1. Carbonated water dispense

2. Non-carbonated dispense

3. 1-second flavor shot

012345

Time

(seconds)

Start

proramming

mode

Exit

programming

mode

4. 2-second flavor shot

5. 3-second flavor shot

6. 4-second flavor shot

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Brak uwag

Cornelius Flavor Fusion 620053922 Informacje Techniczne Strona 7