Cornelius UC 150 Instrukcja Operatora Pobierz pdf (Strona 14)

UC 150 Ice Dispenser Operator’s Manual

Figure 4. Auger Assembly

AUGER ASSEMBLY BREAKDOWN

1. For cleaning, the auger assembly is constructed for simple not tools required breakdown. First remove the tower

cap (item 69) by removing the 3 knurled screws.

2. Once the tower cap is out of the way you will see a wire retainer (item 77). By placing your fingers on the back-

side of the ice chute (item 65) with your thumbs pointing upward, place the thumbs on the retainer wire and with

a slight upward movement push the wire retainer towards the rear of the unit. The retainer should pop out of the

saddle and swing backwards.

3. At this point, you should be able to pull up on the ice chute and remove it from the assembly. You will notice that

the ice chute is made up of three pieces. That is the ice chute, the ice chute cover and the auger gate which is

respectively (Items 65, 66, and 69). Take not so that when reassembling the ice chute, the auger gate cradles in

the ice chute with the short tang side up.

4. The auger (Item 73) can now be removed by just grasping it and pulling up. Notice that the bottom of the auger

has a depression in the form of a D pattern. When replacing the auger, it will be necessary to rotate the auger

after insertion in the tube to engage the motor shaft.

5. Last are the auger housings (Items 74 and 75). They are dislodged by pulling upward. Check their orientation

and the fact that the longer tube is on the front side. When positioning the housings back in the dispenser, the

longer tube should be placed first so as to seat in the lower housing to set up the orientation (top and bottom are

marked on end of the tube tab at the top), otherwise the ice chute spout will not point towards the front of the

dispenser.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 28 29

Brak uwag

Cornelius UC 150 Instrukcja Operatora Strona 14